Publicidad
Idiomas disponibles
Idiomas disponibles
the automatic switch-o , lift up the iron and move it ently from side to side. The control lamp for the
automatic switch-o
Troubleshootin Guide
PROBLEM
Soleplate is not
heatin even thou h
iron is turned on.
Iron does not produce
steam
Spray function does
not work
Steam jet and vertical
steam jet function
does not work
The iron is leakin
White streaks come
throu h the holes in
the soleplate
PRODUCT DISPOSAL
This product complies with European Directive 2012/19/EU on electrical and electronic
devices, known as WEEE (Waste Electrical and Electronic Equipment), provides the le al
framework applicable in the European Union for the disposal and reuse of waste electronic
and electrical devices. Do not dispose of this product in the bin, instead oin to the electrical
and electronic waste collection centre closest to your home.
We hope that you will be satisfied with this product.
20
oes out and the iron will heat up a ain.
POSSIBLE CAUSE
Connection problem
Temperature control is in MIN
position
Not enou h water in tank
Steam control is selected in non-steam
position.
Selected temperature is lower than that
specified to use with steam.
Not enou h water in tank
Steam jet function was used very
frequently within a short period.
Iron is not hot enou h
The temperature settin is too low to
produce steam.
The soleplate has a build-up of scale
because it has not been self-cleaned
re ularly.
SOLUTION
Check main power supply cable, plu and
outlet.
Select adequate temperature
Fill water tank
Set steam control between positions of
minimum steam and maximum steam
(see "iron chart").
Select a hi her temperature
Fill water tank
Put iron on horizontal position and wait
before usin steam jet function.
Adjust to hi her temperature to
steam ironin . Put iron in vertical
position and wait temperature
indicator li ht becomes fixed.
The variable steam knob must be set
on"0"position until the iron is hot.
Do the self-cleanin process. Remember
to do it at least every two weeks.
Publicidad
