Mr Coffee BVMC-EM Serie Manual Del Usuario página 10

Mr. Coffee Reusable Coffee Filter into the brew basket.
4. Place the empty carafe on the unit, centered on the
warming plate.
Press CLEAN so that the Clean indicator lit solid. The
5.
prepared cleaning solution will
begin being brewed through the
coffeemaker. (Figure 5)
6. The entire cycle will take
approximately 45 minutes to
complete. The Clean Indicator will
turn off when the cycle is complete.
7. Discard the cleaning solution and
rinse the carafe thoroughly with clean
water.
8. Fill the water reservoir with 12 cups of clean, fresh water.
9. Place the empty carafe back on the coffeemaker,
centered on the warming plate.
10. Remove and discard the paper filter used during the
cleaning cycle. If a Mr. Coffee Reusable Coffee Filter was
used during cleaning, remove it and rinse it thoroughly
before replacing it in the brew basket.
11. Press BREW NOW so that the Brew Now Indicator is
illuminated and allow the full brew cycle to complete,
rinsing the coffeemaker with hot water.
12. Discard the water from the carafe and rinse the carafe
thoroughly with clean water.
13. Repeat steps 8 through 12 one more time, to ensure the
coffeemaker is fully rinsed.
E19
The Clean Indicator will blink when your coffeemaker has
counted 90 brew cycles. Follow steps 1-13 to complete the
Clean function. The Clean Indicator will turn off once the
clean function is run in its entirety (this will take 45 minutes).
If you wish to stop the Clean function once it has already
begun, press the CLEAN button, the Clean function will stop
and the Clean Indicator will turn off. Press the BREW NOW
button again to ensure the cleaning solution is completely
brewed through the machine and follow steps 7-12.
If you wish to turn off the Clean Indicator without running a
decalcification cycle, simply press the CLEAN button so that
the Clean Indicator is lid solid and then quickly press the
CLEAN button again and the Clean Indicator will turn off.
Figure 5
Please note that we strongly recommend that you run the
Clean function in its entirety when prompted by the Clean
Indicator to ensure that your coffeemaker's performance is
not affected over time.
If the Clean Indicator is not illuminated, but you wish to use
the Clean function, you can still follow steps 1-13.
Cleaning Frequency
TYPE OF WATER CLEANING FREQUENCY
Soft Water Every 80 Brew Cycles
Hard Water Every 40 Brew Cycles
E20