Samson MD1 Pro Guia De Inicio Rapido página 6

Connecting Speaker Level Signals
The MD1 Pro provides the capability of tapping off the signals from amplifiers, such as the output of a
guitar amp or any power amplifier. You can even use MD1 Pro to connect to the speaker output of a con-
sumer stereo system to a mixer or PA system.
WARNING: Be sure that the pad switch is set to the -30dB position before connecting the signal from the output
of any amplifier.
The following diagram shows how to connect the powered output of a guitar amplifier to a mixer.
Speaker Output
Guitar Amplifier
Speaker Input
Guitar Cabinet
Front Panel Rear Panel
Link
Outputs
Mixer
The MD1 Pro can accept signals up to
40 volts when the pad switch is in the
-30dB position. Please use the following
chart to calculate the maximum power
Balanced output based on output impedance that
Output
will safely work with the MD1 Pro:
Power
800 Watts
400 Watts
200 Watts
100 Watts
Impedance
2Ω
4Ω
8Ω
16Ω