Output Connection - Work Pro W PA 5506 Instrucciones De Usuario

EN
Aux Connection (Input)
The equipment provides 4 auxiliary input which may be used for connecting other signal sources
such as a Radio Tuner, CD or Cassette player. A slide switch is located near by AUX1/MIC 2 on the
rear panel for selection of Mic2 or Aux1. Aux 2 ~ 4 inputs are a dual RCA jack and has a stereo to
mono converter for each channel
PIN SLEEVE
RCA plug connector
High Level Input Connection
The "High Level" terminal is for connecting the signal sources from other amplifier output, which
is normally connected to the speaker.

Output Connection

There are 5 output terminals on the rear panel. Each terminal ha s 3 speaker outputs: 8 ohm, 70V
and 100V. Use only one of these outputs for connection.
7. Operation
After all connections are completed, turn the Input Source Selection Switch of each channel to set
on the corresponding position for the signal source. If necessary, turn the bass, treble, and volume
control to what you desire.
Before using the microphone 1 on the front panel to broadcast, make sure the level (volume) control
of MIC 1 is at proper position (not at maximum position). Set the push switch of each channel to
control the mute function of its own channel signal source. Switch-down is to mute signal source,
only the voice from MIC 1 can be heard, while switch-up does not mute signal source, both voice
from MIC 1 and channel signal can be heard. If n ecessary to adjust the volume further, turn the
level control of MIC 1 and/or of Channel 1 ~ 5.
PA 5506 User Manual/Manual de uso Pag. 6