OPERATION
PATIENT PREPARATION
DANGER
CLEAN THE PATIENT TREATMENT AREA THOROUGHLY WITH AN
ANTIMICROBIAL SOAP AND CLEAN WATER AS PER INDUSTRY/ FACILITY/
REGULATORY STANDARDS, AND UNIVERSAL SKIN WASHING PROCEDURES.
FOLLOWING THE SKIN WASHING PROCEDURE, APPLY A HOSPITAL GRADE
ANTISEPTIC SKIN CLEANSER, PER THE CLEANSER MANUFACTURER'S
RECOMMENDED INSTRUCTIONS FOR USE.
REFERENCE THE MAINTENANCE SCHEDULE AND MAKE CERTAIN THE
REQUIRED MAINTENANCE HAS BEEN PERFORMED PRIOR TO STARTING THE
UNIT.
STARTING TREATMENT
STARTING
Make certain all control panel settings have
been made, unit is preheated and patient
is in proper position with sleeve(s) secure
prior to starting the treatment. Refer to
pages 13 - 15 for setup of the unit.
Press "START" button to begin treatment.
STOP TREATMENT
21
Fluidotherapy ® - Dry Heat Therapy
STOPPING
Treatment will automatically stop when the
treatment time reaches zero.
Should it be desired to stop treatment
before the timer reaches zeros, push the
"STOP" button.
NOTE:
Should the treatment be stopped before
the timer reaches zero, it will be necessary
to re-set the "TREATMENT TIME" in order to
complete the prescribed treatment.