Atlas Copco MT Focus 400 CHN Instrucciones Del Producto página 23

MT Focus 400
Torque not reached
Total torque too low
Unscrew
Controller system information
To view the information:
1. Press either the UP or the DOWN button.
2. Select System information in the menu.
3. Press OK.
4. Scroll through the information, using the UP and DOWN buttons.
• Model: The controller model.
• S/W ver: The controller software version.
• Bootloader ver.: The bootloader software version.
• System S/N: The controller serial number.
• Chip S/N: The controller usb-chip serial number.
• Tool S/N: The tool serial number.
• Tool type: The tool type.
• Tool temp: The current temperature in the tool.
• Tool A/D: The sampled current value from the tool A/D converter.
• Tool S/W: The tool software version.
• Friction: The internal friction in the tool.
• No. tightenings: The total number of tool cycles, including unscrew
and Not OK tightenings.
• Supply Voltage: The controller supply voltage.
5. Press OK when done.
EN
The defined Min. torque for the step has not been
reached.
Total step torque is lower than Min. allowed torque.
Unscrew process active.
© Atlas Copco Industrial Technique AB - 9836 791600 00
Troubleshooting
23