Atlas Copco MT Focus 400 CHN Instrucciones Del Producto página 7

MT Focus 400
NOTE
• The torque measuring function in the controller is sensitive to strong
magnetic fields. Do not place magnetic items, for example bits, on or
near the controller.
NOTICE Make sure the cable is not bent more than a radious of 55 mm (2.2 in).
Connecting accessories
CAUTION
• The internal 24 V supply can be loaded with max 700 mA. If the sum of all
loads tend to exceed this value - use an external +24 V source.
Serial interface (RS232-C)
3-pole socket connector for the serial interface.
COM port settings: 115200 Baud, 8 Data bits, 1 Stop bit, No parity, No hand-
shake.
Use a 3-pole pin plug from the Binder 719 Series.
EN
© Atlas Copco Industrial Technique AB - 9836 791600 00
Installation
7