RODI home R300 Manual De Instrucciones página 14

Installing the elements
PT
EN
Attention: This equipment is already assembled at the factory. Carefully observe all parts of the installation process.
FR
ES
Install the rubber gasket according to the following method:
A
Rotate the metal mounting ring clockwise, separating it from
the equipment's body.
C
3
4
5
6
Remove the clamping ring and fiber joint from the sink flange.
The sink flange and the rubber gasket should be together.
B
B1
B2
B3
Raise the metal mounting ring to the sink flange (B1). First
remove the elastomeric seal (B2) and then the metal mount-
ing ring (B3).
D
D1
D2
Insert the rubber gasket and the clamping ring from the
bottom of the sink on the sink flange. Tighten it in the di-
rection of the arrows until the sink flange stops oscillating
(D1). Then place the sealing plug and cover with water un-
til it is submerged. Check that everything is well sealed to
avoid water loss (D2).
RODI INDUSTRIES, S.A. | 14
1
3
4
5
6