RODI home R300 Manual De Instrucciones página 15

E
Place the metal mounting ring when installing the elastomer -
ic seal. Attach the heatsink ring to the elastomeric seal (this
should be placed with the widest part facing down). Raise
the metal mounting ring to allow placing the elastomeric
seal. Use your fingers to gently press along the entire edge
of the elastomeric seal. Let the metal mounting ring fall on
the elastomeric seal and check that it is properly fixed.
Fixing the drain hose
F
Connect the elbow discharge pipe to the waste disposal
body. Make sure that the sealing o-ring is in place and that
the screws are tightened. Check that there are no water
leaks.
WARNING: The electrical connection of this
equipment must be made by a qualified profes­
sional. Do not turn on the equipment before its
complete installation.
Connection of the waste disposal body with the
elements
G
Aim the waste disposal body at the bottom of the fixing de-
vices and secure the equipment latch to the metal mount ing
ring (G1). Rotate the metal mounting ring to the right about
6mm (G2). Leave the equipment temporarily closed.
15
RODI INDUSTRIES, S.A. |
G2
G1
PT
EN
FR
ES