Digifast commander cmd 77 Manual Del Usuario página 25

How to set up your controller for PC with receiver
Press L1 or R1 and Home button around 3 seconds to activate controller. Insert USB wireless receiver into computer.
You can push both the start (+) and back (-) buttons to switch between the Direct input and X-Input mode. The RGB LED
is blue for X-Input and green for Direct input.
How to set up your controller for PC with data cable
Connect the USB data cable with this controller to PC, the motor will vibrate for a few seconds. The default mode on PC is
X-Input.
How to set up your controller for PSX3 with receiver
Press the back (-) and Home buttons around 3 seconds to start the controller; then connect the receiver with your console.
25