Opranic P6 Hybrid Serie Manual De Instrucciones página 8

Fitting
The appliance is already pre-assembled
on delivery. The heating appliance must
not be fitted immediately below a wall
socket.
Wall fitting
When installing the appliance on a wall,
observe the minimum clearance to walls
and objects according to the Technical
Data chapter.
• Install the P6-series, as shown in the
following picture:
•
P6H/V-550/-900/-1200 Fitting
1. Position the bracket on the wall.
2. Mark the 4 corner holes of the bracket
on the wall.
3. Drill 8 mm holes on the wall. Use the
raw plugs and screws provided.
- The screws must protrude approx.
0.5 cm from the raw plugs
4. Use screws size 6 x 50 mm
5. Hang the appliance on the bracket and
lock it by sliding the movable lock so
that it hangs securely.
1
2
No. Description
1 Rear side
2 Threaded insert for fitting on
standing base
3 Removable wall bracket
Commissioning
Information
When first switched on, or after a long
period of not being used, smells can form.
When setting up the appliance, observe
the minimum clearance to walls and
objects according to the Technical Data
chapter.
• Before switching on the appliance
again, check the condition of the
mains cable. İf there is doubt as to
the fault-free condition, call customer
services.
• Place the appliance upright and
securely or hang it horizontally.
• Avoid tripping hazards when placing
the mains cable of other electric
cables, especially when setting the
appliance up in the middle of the
room. Use cable ducts.
• Ensure that extension cables are fully
unwound or unrolled
• Ensure that no curtains or similar are
in the immediate vicinity.
Connect mains cable
• Connect the mains plug to a
correctly fused mains socket.
8
3
3