Publicidad
Idiomas disponibles
Idiomas disponibles
the dust. Allowing dust to get into your mouth or eyes, or lay on your skin may
promote absorption of harmful material. Always use properly fitting NIOSH/OSHA
approved respiratory protection appropriate for dust exposure, and wash exposed
areas with soap and water.
EXTENSION CORDS
Grounded tools require a three wire extension cord. Double insulated tools can use either a two or
three wire extension cord. As the distance from the power supply outlet increases, you must use a
heavier gauge extension cord. Using extension cords with inadequately sized wire causes a serious
drop in voltage, resulting in loss of power and possible tool damage. Refer to the table shown below to
determine the required minimum wire size.
The smaller the gauge number of the wire, the greater the capacity of the cord. For example: a 14
gauge cord can carry a higher current than a 16 gauge cord. When using more than one extension
cord to make up the total length, be sure each cord contains at least the minimum wire size required.
If you are using one extension cord for more than one tool, add the nameplate amperes and use the
sum to determine the required minimum wire size.
Guidelines for Using Extension Cords
•
If you are using an extension cord outdoors, be sure it is marked with the suffix
"W-A" ("W" in Canada) to indicate that it is acceptable for outdoor use.
•
Be sure your extension cord is properly wired and in good electrical condition.
Always replace a damaged extension cord or have it repaired by a qualified person
before using it.
•
Protect your extension cords from sharp objects, excessive heat, and damp or wet areas.
Recommended Minimum Wire Gauge for Extension Cords (120 Volt)
Nameplate
Extension Cord Length
Amperes
25 Feet
(At Full Load)
0–2.0
18
2.1–3.4
18
3.5–5.0
18
5.1 –7.0
18
7.1–12.0
18
12.1–16.0
14
16.1–20.0
12
SPECIFIC SAFETY RULES FOR HOBBY TOOLS
DO NOT LeT cOmfOrT Or famiLiariTy wiTh prODucT (gaiNeD frOm repeaTeD use) repLace sTricT
aDhereNce TO hObby TOOL safeTy ruLes. if yOu use This TOOL uNsafeLy Or iNcOrrecTLy, yOu caN
suffer seriOus persONaL iNjury.
1. Use only accessories rated for the speed recommended on the tool warning label or higher. Wheels and
other accessories running at speeds greater than rated can flay apart and cause personal injury.
2. Hold tool by insulated gripping surfaces when performing an operation where the cutting tool may contact
hidden wiring or its own cord. Contact with a "live" wire will also make exposed metal parts of the tool
"live" and shock the operator.
3. Always hold the tool firmly in your hands before switching the tool "ON". The reaction to the torque of the
motor as it accelerates to full speed may cause the tool to twist.
4. Always disconnect the power cord from the power source before making any adjustments or attaching any
English
50 Feet
75 Feet
18
18
18
18
18
16
16
14
14
12
12
10
10
8
100 Feet
150 Feet
18
16
16
14
14
12
12
12
10
8
10
8
8
6
200 Feet
16
14
12
10
8
6
6
Publicidad
