Publicidad
Idiomas disponibles
Idiomas disponibles
English
Collet Sizes:
Your Hobby Tool is designed to accomodate the most popular 1/8" diameter accessories. This portion of the
Manual explains many of the most popular bits on the market. This Hobby Tool Kit however does not include all of
the accessories describe.
Balancing
:
For best results, be sure to balance each accessory in the collet. The high RPM of the tool makes imbalanced
accessory very detectable as a wobble will occur while the tool is running.
To balance an accessory:
1. Stop the tool.
2. Loosen the collet nut.
3. Rotate the accessory 1/4 turn.
4. Tighten the collet.
5. Run the tool.
Continue adjusting as needed. You will hear and feel when the accessory is properly balanced.
GUIdE FOR ROTARY TOOL BITS
Sanding BandS:
Sanding Bands of Different Grits and Sizes are used to sand curves in wood or plastic. Use a larger Sanding Band
for curves with a larger arc. Finer grits give a smoother finish; coarser grits offer more aggressive sanding. Choose
a Sanding Mandrel that matches the Band you want to use. Loosen the screw in the top of the Sanding Mandrel.
Slide the Band over the mandrel, and tighten the screw to expand the rubber drum and secure the band.
Wire BruSheS:
Wire Brushes and Cup Wheels are for smoothing, de-burring, and cleaning metal surfaces. Use to remove paint,
rust, corrosion, and weld slag.
Brushes should be run at operating speed for at least one minute before using. This allows loose wires and
bristles to be discharged prior to work application. Wire and bristle brushes must never be operated at speeds
greater than 15,000 rpm. Bristles or wires can be thrown from the brush at higher speeds. 15,000 RPM is
approximately halfway on the speed dial of your variable speed rotary tool. Do not use on the mini-Rotary Tool.
Wear protective gloves and face shield when using wire brushes.
The Silver/Grey brushes are carbon steel general-purpose brushes. The Gold/Yellow Brushes are Brass Brushes,
which will work better on softer metals like Copper, brass, or precious metals.
BriStle BruSheS:
Bristle Brushes are for cleaning and de-burring softer, delicate, or antique metals (such as Gold and Silver) and
various non-metallic surfaces such as graphite and rubber. Use with polishing compound for faster results.
aluMinuM Oxide Sand paper,grinding StOneS,
WheelS and pOintS (red/BrOWn):
Aluminum Oxide Bits are for grinding and shaping metals of all kinds. Sharpen scissors, screwdriver Tips, Tools,
Blades, Milled, uneven surfaces. De-burr metal pieces after cutting. Clean up welds. Remove Rust. Re-sharpen
with provided dressing stone.
The wheels must be mounted on the provided mandrel to be used. Loosen and remove the screw in the top of the
mandrel. Position the wheel between the two pink grommets. Replace and tighten the screw to secure. the wheel.
SILICON CARBIdE GRINdING STONES,
WHEELS & pOINTS (BLUE):
Publicidad
