Descargar Imprimir esta página

AIRFORCE Centrale on board B4O 83 Montaje Y Modo De Empleo página 68

Ocultar thumbs Ver también para Centrale on board B4O 83:

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

GB
I
POWER LIMITER
Setting the power limiter should only be carried out by a registered and qualified installer.
Please read the safety regulations and the installation instructions carefully.
DANGER
The hob is equipped with a power limiter. If the total power of operating cooking zones exceeds the
maximum available amount of power, the power is automatically reduced. The display of the cooking
zone who is being reduced in its power is first flashing; the level is then automatically reduced to the
highest available power.
The limiter is factory set at 7400W, but this setting can be changed up to 1400W in steps of 100W
each..
Power limiter configuration
Make sure there are no pots or pans on the hob before you start!
1.
Disconnect the appliance from the main power supply by removing the power connector from the
socket, by removing the fuse or turning the circuit breaker off.
2.
Reconnect the appliance to the power supply.
The minute minder key is flashing.
Perform, within 2 minutes after reconnecting the hob to the power supply, the following
steps.
Make sure all cooking zones are switched off.
3
Touch and hold the minute minder key.
4.
Then, touch each cooking zone key counterclockwise (start with the cooking zone key on the front
right).
FUNZIONAMENTO
OPERATION
68
68

Publicidad

loading