Flo 79502 Manual De Instrucciones página 21

EN
vision. Local regulations may restrict the operator's age.
Never work with the machine if persons, especially children, or pets are in the immediate
vicinity.
Do not use the shears to cut branches or lignifi ed plant shoots. Do not use the shears for
cutting people's hair or dog shearing.
Maintain balance while working. Do not reach too far so as not to lose balance. Always maintain
secure posture while on slopes. Always walk and never run while working with the device.
Never touch moving dangerous parts before the safety key has been ejected from the device
and the moving parts have come to a complete stop.
Although the device has been designed to be safe, it is not possible to completely eliminate the
residual risk associated with the possibility of injury in the event of body contact with sharp edg-
es and the risk associated with exposure to noise and vibration. Therefore, use personal pro-
tective equipment and follow the instructions to reduce the risks associated with residual risks.
Always wear suitable footwear with full upper and non-slip soles, and long trousers when
working with the device.
Always remove the safety key: when the user leaves the device, before removing the cause
of the blade jamming, before checking, cleaning or working on the device, before checking
the device for damage after hitting a foreign object, before immediate checking of the device
after it starts to vibrate excessively.
Never operate the device with damaged guards or without safety devices.
Do not work with the device in bad weather conditions, especially when there is a risk of a
lightning strike.
EQUIPMENT INSTALLATION
The shears are supplied complete. The device has two interchangeable tools i.e. grass trimming attachment and hedge trimming
attachment, which must be used according to the instructions in the manual.
Warning! All operations mentioned in this chapter must be carried out with the device turned off . Make sure that the tool's power
switch is not pressed and that the safety key has been removed from the tool.
Installing the grass and hedge trimming attachments
The attachments have sharp edges, that is why it is recommended to be careful and replace them while wearing protective gloves.
The replacement does not require any additional tools.
Press and hold both the attachment lock buttons (II). Put the attachment on the tool housing so that the attachment mounting part
fi ts the tool housing around the entire circumference. Release the pressure on the buttons. This will cause the attachment latches
to slide into the mounting holes in the housing and lock the attachment in the tool (III).
Correctly installed attachment cannot be removed in other manner than by pressing both lock buttons and removing it from the
tool.
Installing the adjustable-length holder (applies only to 79503)
The holder is mounted to the rear lower part of the tool housing. Insert the holder into the guides cut on both sides of the tool
housing (IV) so that it snaps on the side and bottom wall of the housing (V). After mounting the holder to the housing, connect
the holder cable to the socket in the tool handle (V). This will allow the tool to be controlled by means of a power switch located
in the holder grip.
To remove the holder gently pull the latch on the bottom of the housing and then pull the tool out of the holder.
PREPARING FOR WORK
Adjusting the additional holder (applies only to 79503)
Warning! All operations mentioned in this section must be carried out with the device turned off . Make sure that the tool's power
switch is not pressed and that the safety key has been removed from the tool.
O R I G I N A L I N S T R U C T I O N S
21