Publicidad
Idiomas disponibles
Idiomas disponibles
4. Connect the charging jack into the receptacle on the bottom of the trimmer. Plug
the adapter into any electrical outlet (at the voltage listed on the label affixed to the
adapter). The charging indicator will blink to indicate that the charging has begun.
Charging is complete after 4 hours. User will see LED light has stopped blinking
and is now steady lit.
5. The adapter may become warm while charging. This is normal.
6. Preserving the batteries: In order to maintain the optimum capacity of the
rechargeable batteries, the trimmer should be recharged for 4 hours approximately
every 6 months.
7. Slide the switch to "I" position.
8. Make sure the switch is in the "0" position when the trimmer is not operating.
9. Remove hair trimmings and debris from the blades using the provided cleaning
brush. Wipe the housing clean with a dry cloth.
10. Apply a few drops of lubricating oil to the blades, and wipe off any excess oil with a
dry cloth. This last procedure is important for the proper maintenance of the blades.
11. If the charging light starts to flash rapidly (more than 4 flashes per second) then
the appliance is faulty. If this happens then please stop charging and remove the
adapter from the mains and contact an authorized Service Center.
FOR DIRECT PLUG-IN OPERATION
Make sure trimmer is off. Connect charging jack into the receptacle at the end of
trimmer and plug the adapter into power outlet.
ON/OFF SWITCH
To operate, simply slide switch to "I" position. To stop operation, set to the "0" position.
FX787GBPUZ IB-22_078.indd 5-6
FX787GBPUZ IB-22_078.indd 5-6
VERY IMPORTANT: Blades must be cleaned and oiled on a regular basis for
proper functioning. Failure to regularly clean and oil the blades will void the
warranty.
REPLACING (REMOVING) BLADE SET
To remove the blade set, turn the trimmer to the OFF position and unplug it from the
electrical outlet. Turn the trimmer upside down so that the teeth of the trimmer are
facing down. Place the trimmer on a flat surface and using the screwdriver, loosen the
fastening screws from the blade set. Remove the blade set from the trimmer (see Fig. 1).
Fig. 1
Blade set
Blade screws
To install or replace your trimmer blade set, reverse the procedure, aligning the blade
cushion shaft into the moving blade cushion (see Fig. 2). With the blade held in place,
replace blade screws and tighten loosely. Turn the trimmer over and align the blade set
parallel to the trimmer's upper housing.
Fig. 2
Screws
Blade cushion
Moving blade
Fixed blade
Screws
Screw holes
2022/4/13 3:57 PM
2022/4/13 3:57 PM
Publicidad
