Publicidad
Idiomas disponibles
Idiomas disponibles
EN
ATTENTION!
For first time use, the following operation is recommended.
WARNING!
Make sure the power cord is not plugged in before you start.
Lay TUTTOSTEAMY on a flat and steady surface.
9.1 FILLING WITH WATER
ATTENTION! Fill TUTTOSTEAMY with filtered water (from ZEPTER water
filtration systems) or with tap water with a low mineral content (soft water).
Do not put any type of detergent or chemical substance into the boiler.
a) Unscrew the safety valve (9) anti-clockwise (picture A).
b) Pour in a suitable quantity of water (min. 0.5 l – max. 1.6 l).
Use a funnel
for higher precision (picture B).
c) Screw safety valve back – clockwise. Ensure that safety valve is properly
closed/tight.
NOTE: TUTTOSTEAMY is equipped with a safety valve that prevents the
valve from opening as long as steam pressure is high. Current steam
pressure can be monitored by looking at the steam pressure indicator
(8).
NOTE: When water level is too low, the orange indicator light comes
on (6).
9 - GETTING STARTED
A
9.2 CONNECTING OR REMOVING THE FLEX TUBE (31)
a) Lift the socket cover
b) Insert flex tube into the socket (11) (picture C).
The pin has to be turned upwards and inserted into the socket cover opening
(picture D).
c) Release the socket cover.
To remove the flex tube observe the following steps:
a) Lift the socket cover above the safety pin.
b) Gently pull the flex tube out of the socket.
c) Release the socket cover.
ATTENTION!
Ensure that the safety pin is correctly attached by pulling it lightly.
9.3 CONNECTING THE ACCESSORIES
In order to use the device correctly and get the requested results, it will be
necessary to insert the proper accessories onto the extension tube (32).
B
WARNING! The accessories heat up during use. Be careful when replacing
or removing the accessories.
C
ATTENTION! If the appliance is being
used for the first time, apply the hook (41)
onto the brush coupling (37). For more
information, please refer to chapter 11 "Usage
of accessories". Put the hook in the correct
position (picture E) and secure it with the
screws (42). Ensure the hook is fixed properly
and cannot be lost during use.
10
D
Publicidad
