Publicidad
Idiomas disponibles
Idiomas disponibles
EN
SETTING THE TEMPERATURE
Set the required ironing temperature by turning regulator dial (3),
corresponding power LED is switched ON.
Type of fabric
Synthetic fabric (e.g. acrylic, viscose, polyamide and silk)
Wool
Light cotton
Linen/ cotton
ATTENTION!
Steam ironing is only possible at a temperature higher than
Note: The steam regulator (10) on the main body should be set to position 3.
WARM UP (energy saving function)
Iron status LED light is flashing when the iron is warming up. When required
temperature is reached; the red LED diode lights up.
STANDBY (energy saving function)
If the iron is not in use for 30 seconds in horizontal position or 15 minutes in
vertical position, it will automatically go into standby. The iron status LED light
and power LED light will flash. To re-activate the iron, just start ironing again.
IRONING WITH THE STEAM IRON
CAUTION!
Follow the ironing instructions are for the laundry or clothes to be ironed.
Direct the first steam jet onto a separate cloth. While ironing, only press the
steam button at a suitable distance. Let the iron slide lightly over the laundry.
No excessive pressure is required. Always iron on an ironing surface that is
permeable to steam and heat-resistant. Select the ironing temperature
according to the type of material. Follow the instructions on the garment
labels. Always iron completely dry laundry to prevent further creases from
forming. Iron delicate clothes inside out.
BEFORE STARTING TO IRON
Separate the laundry according to the types of material while checking for any
repairs to be made. Also check that all of the laundry is clean, without any stains.
• Ironing at a maximum iron temperature of 200 °C
• Dampen the material
Temperature
• Ironing at a maximum iron temperature of 150 °C
setting
• Put a damp cloth between the iron and the garment
• Ironing at a maximum iron temperature of 100 °C
• Put a damp cloth between the iron and the garment
• Textiles are not to be ironed
FRESHENING UP CLOTHES
.
Adjust the required temperature with the
temperature regulator (3) of the iron. Set the
steam intensity regulator (10) on the main
body to 3. Spray steam onto the garment
hung at a distance of about 20 cm. For delicate
materials, it is recommended that you place a
clean cotton cloth over the garment before
steam spraying (Picture E).
16
Publicidad
