Publicidad
Idiomas disponibles
Idiomas disponibles
EN
DANGER!
•
Repairs must only be performed by a Zepter Service Centre and in
accordance with national and local safety regulations. Unauthorised
repairs could cause injury or machine damage. The manufacturer cannot
be held responsible for unauthorised repair work.
ISSUE
The flow of steam does not come out regularly and
is accompanied by water spray.
The steam cleaner is ready for use but no steam is
released.
An accessory becomes detached during use.
14 - TROUBLESHOOTING
CAUSE
The boiler has been filled with too much water.
The steam plug has not been correctly attached.
The steam intensity regulator is in its closed
position (0).
The accessory is clogged.
The accessory has not been properly connected.
NOTE: Despite proper use of the appliance, problems may occur.
The following table shows some of the possible problems and their
corresponding solutions. Should our advice not assist, please contact
your local Authorized Service Centre.
SOLUTION
Unscrew the safety valve, turn the device up side
down and drain the excess water. Be careful not
to overfill the appliance (max 1.6 litres).
Check the plug has been correctly inserted into
the steam socket.
Turn the steam intensity regulator to the open
position 1-6.
Check the accessories.
Connect the accessory properly.
18
Publicidad
