Publicidad
MODELO CON CONEXIÓN POLARIZADA
La base de carga está diseñada para utilizarse en un circuito nominal
de 120 V~ y tiene una clavija polarizada como se ilustra en la Figura A.
Cuide su estación de limpieza de altos y bajos voltajes
Un adaptador puede utilizarse temporalmente para conectar la clavija a un contacto no
polarizado. El adaptador temporal sólo podrá utilizarse mientras un electricista calificado
instala un contacto polarizado como el que se ilustra en la Figura A.
Estación de limpieza
Entrada: 120 V~ 60 Hz 700 W
Salida: 19 V
0.6 A
ADVERTENCIA
Una conexión inapropiada puede provocar riesgo de choque eléctrico, revise por medio de un electricista capacitado que el
contacto que se utilizará esté debidamente polarizado. No modifique la clavija de la máquina, si la clavija no ajusta en el
contacto, instale uno llamando a un electricista capacitado.
COMPONENTES DE LA ASPIRADORA ROBOT
Estación de limpieza
Tapa superior
Posición para abrir
Almacén de
bolsa de polvo
Luz indicadora
Sensor infrarrojo
Puerto de succión
Contacto de carga
3 sensores
anti-caída
Cepillo lateral
Interruptor principal
Tapa de batería
Ruedas
Depósito de
polvo y agua
4 Cepillos
laterales
Pared
virtual
Limpie los accesorios después de su uso para mantenerlos en buenas condiciones.
15
FIGURA. A
Clavija
Polarizada
Botón Encendido / Apagado
Luz LED
Botón de
estación de
carga
Indicador
Wi-Fi
Depósito
de polvo y agua
Defensa anti impacto
con 11 pares de sensores
Rueda giratoria
Cepillo lateral
Ruedas
Cepillo giratorio
Contactos de carga
Puerto de recolección de polvo
Cepillo de limpieza
Control
Filtro
HEPA
remoto
CLEANING THE COMPONENTS OF DUST AND WATER TANK
Although your Robot Vacuum Cleaner has a self-cleaning system, it is recommended to clean the dust tank as shown below:
1. Press the bin release button to remove it
Sensor anti impacto
Cleaning and replacing the dust bag
of the cleaning base
1. Unplug the cleaning base from the power outlet supply and open the
main cover.
2. Pull up the dust bag handle and remove it from the cleaning base.
3. Throw the used dust bag in your trash can.
4. Install a new dust bag in the cleaning base by sliding the dust handle
down.
5. Close the main cover and connect back the cleaning base to the power
outlet supply.
Note: The dust bag can go up to 120 days without being replaced
2. Empty dust tank into the trash can
Cleaning the filter of the
Robot Vacuum Cleaner:
1. Remove the filter by pulling the white tab
Note: If HEPA filter needs to be cleaned please hold the edge of filter
base and take it out for cleaning. If there is too much dust on the
filters, you can clean them with water.
2. Shake off the debris by tapping the filter against your
garbage container.
After filters are completely dry (dry them in the sunlight
for 8 hours, in general), put them back into the dust
container.
Cleaning the brushes:
1. Turn the Robot Vacuum Cleaner upside down.
- Open safety to remove main brush.
- Clean the main brush and let completely dry before
using it again.
Note: The main brush is consumable and should be cleaned at least
once a week. To ensure the cleaning effect, it is recommended to
replace the main rush every 6-12 months of use.
2. Remove the side brush and then clean it with a rag.
Note: Side brushes are consumables. To ensure the cleaning effect, it is
recommended to replace them every 3-6 months.
3. After the Robot Vacuum Cleaner works for a certain
period, cliff sensor windows shall be cleaned.
4. Clean the main wheel with the brush cleaning
included.
5. Remove dust from the anti-drop sensors to maintain
better performance.
Clean the duct cover of the
cleaning base
If the dust bag is replaced but the orange LED indicator
light is still on, it is recommended to check if the duct
cover of the cleaning base is blocked or has something
stuck.
1. Unplug the cleaning base from the power outlet supply
and turn the base over.
2. Remove the duct cover from the base with a screwdriver
and remove the object that is blocking the channel.
3. Replace the duct cover with a screwdriver and return
the base to its original position.
12
Publicidad
