Lincoln Electric MOBIFLEX 400-MS Instrucciones Para El Uso página 18

A
B
Fig. 6.2: Filter replacement
6.2.2 Spark arrester
Replace the spark arrester (Fig. 6.2B):
- when it is clogged or saturated and cannot be cleaned using a
vacuum cleaner; or
- when it has been damaged.
In case the spark arrester has been damaged, it is
recommended to also replace the main filter.
6.3 Emptying the dust tray
Dust and dirt particles from the main filter end up in the dust
tray underneath the machine. To avoid the dust tray to overflow
thus polluting the workshop, it needs to be emptied on a regular
basis. Refer to section 6.1 for the frequency of emptying.
ATTENTION!
Always wear face mask and gloves during emptying
the dust tray.
WARNING!
Never open the dust tray while the motor is running.
Fig. 6.3
• Loosen the star knob (B), which is accessible from the
underside at the back of the machine.
• Carefully take out the dust tray (A).
The dust tray can be emptied in different ways:
- using an industrial vacuum cleaner (preferred way); or
- empty it in a plastic bag.
• Empty the dust tray. In case of emptying it in a plastic bag,
make sure to seal the bag firmly.
• Slide the dust tray back into the machine.
• Carefully tighten the star knob making sure that the dust
tray is sealed airtight.
0507260020/150709/E Mobiflex 400-MS - Mobiflex 400-MS/C
C
Fig. 6.3: Emptying the dust tray
B
A
EN - 17