Publicidad
Idiomas disponibles
Idiomas disponibles
DCF time signal reception
After the clock receives and displays the outdoor temperature-humidity
reading, it will start searching for the DCF time signal. The clock will start to
search for the DCF time signal with the icon
will last for around 7 minutes. If the fi rst attempt of signal search fails, the
clock will automatically search for the signal again every 3 hours.
NOTE: signal reception is normally better at night and when the weather is
clear. The radio-controlled signal generally takes a few hours to synchronize, so
it is important to manually set the time and date after powering up the clock.
The clock will start searching for a signal every night at 1:00 am, 2:00 am
and 3:00 am. If no reception, it will try again at 4:00 am and 5:00 am. During
reception, do not press any buttons for the best results.
During reception, the clock does not take temperature or humidity
measurement. The temperature and humidity reading will become stable
and accurate after your clock is powered up for approximately 30 minutes.
Once the clock receives the signal, the time and calendar will be updated
and your clock is ready to use.
It is important to set the clock with the correct time zone and DST (on/off)
in accordance with where you live in order to get the correct time after a
successful DCF signal reception.
Searching for signal
(signal is strong)
Searching for signal
(no signal or weak signal)
Received signal successfully
Fail to receive signal
fl ashing. The fi rst reception
Both the "M" icon and the wave bars are
blinking
Only the "M" icon is blinking. Place your clock in
another location with a stronger signal if it keeps
failing to receive the DCF time signal overnight
e.g. closer to the window or away from other
electronic devices.
Time and date are set and both the "M" icon
and the wave bars become static.
The "M" icon becomes static and no wave
bars appear.
To set the clock manually
Function
Button
Set Time
Set Weather
Complete Set Up
DCF Time Signal
Reception
Steps
Set Hour
MANUAL SET
Press and hold
button, the hour
24
digits
fl ash, press
or
to set hours.
Set Minute
MANUAL SET
Press
button once again, the
minute digits fl ash, press
or
to set minutes.
+
–
Press and hold
or
to accelerate setting.
Set The Weather Icon To The Current
Weather Outside
MANUAL SET
Press
button once again, the
weather icon
(default) fl ashes, then
Partly Sunny
press
or
to select a weather icon with
reference to the local weather forecast on TV.
This setting will help to calibrate the built-in
barometric sensor and enable the clock to
display the relevant weather forecast faster.
Set The Time Interval Of Auto-Scroll Display
Of Different Outdoor Sensors
MANUAL SET
Press
button once again, the
5
auto-scrolling icon
appears and
(5
S
seconds) shows at the outdoor temperature
10s
section. Press
or
to select
(10
20s
30s
seconds),
(20 seconds) or
(30 seconds).
MANUAL SET
Press
button once again to
complete your set up and quit to normal
time display or leave the clock for 10 seconds
without pressing any key.
At normal time display mode, press and hold
WAVE
button to activate the manual reception.
WAVE
Press and hold
again to stop and
disable the manual reception.
EN
Publicidad
