Publicidad
Idiomas disponibles
Idiomas disponibles
Function
Button
Turn On/Off Radio-
Controlled Time
Function
Turn DST On/Off
Set ˚C/˚F
To use the weather forecaster
Your clock has a built-in barometric air pressure sensor which records and
compares the air pressure change per hour to forecast the weather in next
6 hours.
Sunny
Partly Sunny
Rainy
Steps
When the clock is being used in a region
where the DCF time signal is not available,
WAVE
OFF
slide the
switch to
. The clock will
stop searching for DCF time signal.
If you live in an area where DST is not
DST
OFF
observed, slide the
switch to
to
disable the auto-adjustment of Day-light-
saving time.
MANUAL
At normal time display mode, press
SET
button once to toggle Celsius or
Fahrenheit temperature display.
Cloudy
Stormy
Remarks: Moving your weather station clock from one fl oor of a building to
another fl oor will affect the accuracy of your weather station, which should
operate at the same altitude all the time. If you move it to a new location, it
will take 12 hours to become stable and accurate.
The weather station displays the weather forecast for the next 6 hours,
therefore It may not match the current outdoor weather conditions.
Outdoor remote sensor
To Select Sensor Channel And To Use Auto-Scrolling Display Of Outdoor
Temperature-Humidity
Press
one at a time to select and display the outdoor
one at a time to select and display the outdoor
one at a time to select and display the outdoor
one at a time to select and display the outdoor
one at a time to select and display the outdoor
HOLD TO SYNC SENSOR
temperature-humidity of Channel icon
pressing once again will activate the auto-scrolling of outdoor temperature-
humidity readings from each sensor. The
Channel icon.
If You Lose The Outdoor Temperature And Humidity
When both the outdoor temperature-humidity readouts show "--", the
wireless transmission is either interrupted or lost.
Hold
button until "--" fl ashes. The outdoor data should
HOLD TO SYNC SENSOR
display again within 2 minutes. If this does not happen, place the outdoor
sensor next to the clock. Hold
HOLD TO SYNC SENSOR
Then use a pointy object to press
Please ensure:
1. The sensor Channel you select on the clock, matches the Channel
selector switch at the back of the outdoor sensor.
2. The batteries in the outdoor sensor are at a suffi cient level. Observe
if the low battery indicator
appears above the outdoor temperture-
humidity readout.
,
, or
. When
is selected,
will appear on top of the
again until "--" fl ashes.
on the outdoor sensor.
RESET
EN
Publicidad
