LINDR CWP 100 Green Line new Instrucciones De Uso página 20

11.3 Connection and Pressurisation CWP 200 Green Line new, C02/ N2
1. Beverage inlet
2. Beverage outlet
3. Thermostat
4. Keg coupler (A-system, S-system, M-sys-
tem)
5. F 5/8 x 9.5 mm speed fitting
6. F 5/8 x 8 mm speed fitting
7. Y 8 x 8 x 8 mm speed fitting
WARNING: Check that all joints are sufficiently leak-tight after connection.
ATTENTION: For AS models where a stirrer pump is installed, be sure to connect the pump
cable to the socket on the cooler. The pump with stirrer ensures an even temperature in the
entire water bath and cools the beverage up to the tap.
12. PUTTING INTO OPERATION:
1. Connect the air line and the beer line.
2. Connect the recirculation coil to the dispense tower.
3. Pour the liquid into the plastic tank.
4. Connect the cooler to the mains.
5. Switch to turn on the cooler.
20 6. Set the desired temperature on the thermostat - see point 14.
7. Tap the keg, see point 18, tapping the keg.
8. Cooling beverage is now underway. After being cooled, you can dispense the beverage.
WARNING: If a leakage is found, untap the keg according to point 18 and turn off the
device. Fix any leaks found on the tubing. If a leak is found inside the device or you are unsure
how to proceed, contact a service centre.
13. HOW TO WORK WITH SPEED FITTINGS
13.1 Speed Fitting Installation:
Grasp the speed fitting and insert the hose all the way inside the speed fitting body (ca. 20 mm).
The end of the hose must be straight so that it plugs fully into the coupling. If the hose will not go
in, moisten the end of the hose.
8. CO2 pressure reducing valve
9. Beverage
10. JG SS 9.5 x 8 mm speed fitting
11. JG 12.7 x 8 mm speed fitting
12. JG F7/16 x 8 mm speed fitting
Max. Inlet beverage temperature 30 ° C.
(see Fig. 13.)
: