2. Please switch off the machine immediately by setting the switch to '"O"' and
pull out the plug from the mains socket outlet, let the machine to cool down
briefly (for hot laminating) and push the 'ABS' anti-film blockage button on
back whenever there is a blockage of the film.
3. Hold the ABS switch firmly with one hand and pull out the film completely from
the machine's feed opening or delivery opening with the other hand.
4. After you have resolved the blockage of the film and released the ABS switch,
this will go back to its starting position again. Now you can use the machine
again completely.
5. Please contact our service hot line if there is a blockage of the film again.
Cleaning and care
1. Please pull out the plug from the mains socket outlet always, in order to clean
the machine. Take care while doing so that the plug does not come into
contact with any liquids.
2. Allow the machine to cool down before cleaning it.
3. Clean the machine with a slighly moist, soft cloth. Do not use any caustic or
abrasive cleaning agents while doing so.
Delivery:
Laminator GENIE LA 200
Instruction manual
It is possible that additional foils or foil sets are contained.
Technical data
Mains voltage (V)
Consumption
Laminating width
Size of the machine (mm)
Film of utilizable thickness
(microns)
Heating up time
Speed
220 V to 240 V ac, 50 Hz
265W
230 mm
330 x 106 x 60 approx.
80 minimum, 125
maximum
3-5 min. approx.
220 mm / min
The CE Mark on the device confirms conformity.
The Declaration of Conformity can be read online at
www.go-europe.com.
The «Geprüfte Sicherheit» mark (GS tested safety
mark) certifies that the product satisfies the
requirements defined by the German Product
Safety Act (ProdSG).
The GS tested safety mark indicates that when
implemented for its intended use and in the event of
foreseeable misuse the identified product will not
endanger the safety and health of the user. It
concerns a voluntary safety mark which was issued
by an authorized testing institute.
9