Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
9. Screw one end of wall strap (EE) to the
right back panel (B) with #8-32 x 3/8 in.
bolts (BB) and #8-32 nuts (CC). Secure
the other end to the wall with ST4 x 20
mm screws (DD). Repeat for another wall
strap (EE).
Note: This cabinet should be anchored to the
wall using the wall strap (EE) to avoid any
potential danger from cabinet falling. Check
and see if the top panel (F) is level. If not level
due to uneven floor, the two doors will
probably not be properly aligned. In this case,
use an adjustable wrench (not included) to
adjust the hex nut until the top panel (F) is
level.
Hardware Used
#8-32 x 3/8 in. Bolt
BB
#8-32 Nut
CC
ST4 x 20 mm
DD
Screw
EE
Wall strap
10. Move the unit to the wall, making sure the
back of the unit is flush with the wall.
Feed the ST4.8 x 100 mm pan head
screws (HH) through the 5 x 15 x 1.2 mm
washers (II) and back panels (A and B).
Screw the ST4.8 x 100 mm pan head
screws into wall studs, and tighten
securely.
Note: Screws must be placed into wall
studs. The unit will not be secured if
screwed into drywall. If there is a gap
between the unit and the wall due to
moulding on the garage floor, please make
the unit press against the moulding and be
parallel to the wall.
Hardware Used
ST4.8 x 100 mm Pan
HH
head screw
9
D
x 4
BB
x 4
x 4
CC
x 2
10
II
x 2
II
10
F
B
DD
EE
A
Wall
HH
5 x 15 x 1.2 mm
Washer
A
EE
W a l l
B
x 2
Publicidad
