Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
5. Check and verify the holes in front edge of
base panel (E) and top panel (F) are
aligned with the holes in left side panel
(C) and right side panel (D). If not, check
and make sure the base panel (E) and
top panel (F) are located at the right
place. Tighten the ST4.8 x 10 mm screws
(AA) to the holes to make the unit
securely fixed.
Hardware Used
AA
ST4.8 x 10 mm
Screw
6. Screw leg leveler assemblies
(K) to base panel (E) until tight.
Place the cabinet upright.
5
E
x 12
6
K
8
C
D
AA
E
K
F
E
Publicidad
