Descargar Imprimir esta página

Pulmic PEGASUS 35 Manual De Uso página 7

Ocultar thumbs Ver también para PEGASUS 35:

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 1
PULMIC PEGASUS 35
5. CLEANING AND MAINTENANCE
TANK AND PIPES
Clean the instrument and its pipes after each use, with clean water. Empty
the tank complete. Never leave the sprayer phytosanitary products stored in
the tank, pipes or pump.
FILTERS
This machine has the following filters:
Filling mouth filter (Ref. 1447).
Suction filter (Ref. 14062). It is located in the lower part of the tank and
can be removed for cleaning. After cleaning, it should be reassembled in
its housing in the same way and original position.
Impulsion filter (Ref. 1453). Find in the handle of the sprayer lance.
The correct maintenance of the filters is the best guarantee for the proper
functioning of your sprayer. Clean these filters periodically (every workday)
and replace them if damage.
NOZZLES
The electric sprayer is supplied with quality nozzles. The performance of
this equipment may be reduced if a nozzle with excessive wear or a non
recommended nozzle are used. Replace the nozzle when it present signs
of deterioration.
RECHARGE AND BATTERY MAINTENANCE
The battery is a very sensitive subjected to wear. To
lengthen its life is important to read the charging and
maintenance recommendations.
To recharge the batteries, extract the battery from
its housing by pressing the release lever and moving
the battery (Ref. 13943) outwards (see fig. 1). Then,
connect the charger (Ref. 13980) to the mains through
its mains connection 100/240 V AC.
Next, you must connect the 21 V DC plug to the
battery socket, located on the back side. Then, the
green battery LED will start to blink, indicating that
the recharging process has begun.
www.gruposanz.es
Figure 1
— 12 —
PULMIC PEGASUS 35
On the battery, the indicator light has the following meaning:
1
LEDs ON
CHARGE LEVEL
Less than 20%
21% - 40%
The approximate time for recharging is 4-5 hours (depending on the level of
discharge of the battery). After final charging, remove the connector from
battery housing and then remove the battery charger (Ref. 13980) from the
mains plug.
IT IS RECOMMENDED TO RECHARGE THE BATTERY AFTER EACH
WORKING DAY
Never recharge the battery with extreme temperatures, the charging
temperature range is 0° to 40 °C. It is recommended before starting the
recharge wait a while until the battery gets cool. It is normal for the charger
to warm up slightly during charging.
For extended periods of inactivity, you should remove the battery from the
sprayer and store at half load in a dry and stable temperature (ideal range of
5° to 15 °C), it is also advisable to monitor the state of charge at least once
every six months and whether to proceed with timely recharge depending
on future use.
When replacing the battery, have an original spare part and insert it into
accommodation as instructed. Use only the charger supplied with this
equipment, connected to a power socket AC standard (100/240 V, 50-60 Hz).
EXPLOSION RISK
CONNECT THE CHARGER ONLY IN INDOORS. IN DRY PLACES &
AWAY FROM CHILDRENS. DO NOT USE THE CHARGER IN EXPLOSIVE
ENVIRONMENTS. DO NOT LEAVE THE SPRAYER IN OUT DOORS. &
WITH TEMPERATURES BELOW ZERO.
DO NOT OPEN THE BATTERY OR KEEP NEAR ANY HEAT SOURCES.
LEAVE WASTED BATTERIES IN AN AUTHORIZED PLACE.
www.gruposanz.es
2
3
4
5
41 - 60%
61% - 80%
81% - 100%
— 13 —

Publicidad

loading