Thule RideAlong Manual De Instrucciones página 2

WARNING
FAILURE TO COMPLY WITH THE
MANUFACTURER'S INSTRUCTIONS
CAN LEAD TO SERIOUS INJURY OR
DEATH OF THE PASSENGER/RIDER!
IMPORTANT - READ CAREFULLY AND
KEEP FOR FUTURE REFERENCE.
CAUTION
• Do not attach additional luggage
to the child seat. Any extra load is
best attached to the front end of the
bicycle.
• Do not modify the product in any
way.
• The cycle could behave differently
with a child in the seat. Particularly
with regard to balance, steering and
braking.
• Never leave the cycle parked with a
child in the child seat unattended.
• For any form of crack or if the surface
starts to deconstruct, this indicates
that the life of the child seat has been
reached and it should be replaced.
A professional shall be contacted in
case of doubt.
• Always check the surface temperature
of the product before any use.
• Always ensure that the head of your
child is supported in reclined position.
• This child seat is not suitable for use
during sporting activities.
• Before each ride, ensure the mounted
seat does not interfere with braking,
pedaling, or steering of the bicycle.
• Do not allow any of the child's body,
clothing, shoe laces, or toys to come
in contact with moving parts of the
bicycle.
• A rear reflector that complies with
CPSC regulations must be visible
whether the seat is on the bicycle or
not.
• The load of a child seat may lessen
the stability and alter the riding char-
acteristics of the bicycle, particularly
2
EN
regarding steering and braking.
• Do not use the seat if any part is bro-
ken.
• The bicycle to which the seat is at-
tached must be in good working
order.
• Do not remove the attached key ring,
its size reduces the risk of suffocation
for your child in case of ingestion.
• According to ASTM F1625-00, addi-
tional luggage or accessories should
not be attached to the child seat, as
they may exceed the load limit and
may lessen the stability. Total load
limit for the seat is 18 kg (40 lb).
INSTALLATION
s1. Make sure your bicycle is compatible with this
child seat. If you have any questions, please
check the information supplied with the bicycle,
or ask the bicycle dealer or manufacturer.
s2. Identify the centre of gravity mark and mount
the seat as far forward as possible. Preferably,
have this mark in front of the rear wheel axle, but
on no account more than 100 mm/3.94" (for DE,
Germany, 0 mm) behind a point vertically above
the rear wheel axle.
s3. Make sure the bracket screws and attachment
points are fully tightened, and check them
frequently.
s4. This product is not suitable for use on a moped.
s5. For optimum comfort and safety, make sure that
the child seat does not slope forwards, risking
the child to slide out of it. The backrest of the
seat should slope backwards slightly.
s6. Check that all parts of the bicycle function
correctly with the child seat mounted.
FRAME MOUNTED
s7. Mount the seat as is described in the instruction
manual. Pay attention to maximum and minimum
measurements.
s8. Cannot be mounted on bicycles with square,
triangular or carbon fibre frames.
REAR SEATS FOR ATTACHMENT TO A LUGGAGE
CARRIER
s9. Check the product manual for maximum width
of the luggage carrier.
s10. Mount the seat as is described in the instruction
manual. Pay attention to maximum and minimum
measurements.
s11. Only mount the child seat to a luggage carrier
that conforms to ISO 11243 and has a load
5560140001