Seek Thermal AttackPRO Manual Del Usuario página 26

Care and maintenance
Cleaning and care
The Seek AttackPRO thermal imager requires little maintenance. For
best care, please follow the guidelines below:
• When not in use, the thermal imager should be stored in at an
average room temp of 23˚C (73˚C) and kept clear from potential
physical damage
• If company or department information is added to the thermal
imager, ensure that you do not cover the original product labels or
markings, the thermal imager lens, flashlight window, the
functional buttons, or the display
• To clean the camera housing, use a soft cloth with warm water
only and a mild detergent. Do not use solvents to clean the
camera
• To clean the lens and flashlight, a commercial lens cleaning
solution with more than 30% isopropyl alcohol may be used with
a soft cloth. Gently use the cloth on the lens, as the lens has a
delicate anti reflective coating
• Do not allow any liquids or debris to enter the battery
compartment, and make sure the battery compartment is closed
when handling the device around dirty or contaminated
environments
• Decontamination: please make sure the camera is thoroughly
cleaned, decontaminated, and disinfected before sending to your
reseller or Seek Thermal for service. Contaminants include:
chemical fire extinguishing compounds, radioactivity,
biohazardous materials, and residues from chemical fires
• Seek Thermal reserves the right to charge the full cost for the
decontamination and disinfection of cameras that are shipped to
our service department