General Electric Profile 473 Manual Del Propietário página 13

Clothes take too long
todq
Possible Causes What To Do
Improper sorting
Large loads of heavy fabrics (fike
beach towels)
Controls improperly set
Lint filter is full
Improper or obstructed ducting
• Separate hem T items fi'om lightweight items (generally,
a well-sorted washer load is a well-sorted &yer load).
• Large, heax,y fabrics contain more lnoismre and take
longer to dpy. Separate large, hem T fabrics into smaller
loads to speed (h)_ng time.
• Match control settings m the loadyou are dp)5ng.
• Clean lint filter before every load.
• Check installation instructions fior proper
&rating/venting.
• Make sure ducting is clean, flee of kinks and
unobstructed.
• Check to see if outside wall damper operates easily.
• Check the Installation Instructions to make sure the (hyer
venting is correct.
Blown fuses or tripped circuit • Replace filses or reset circuit breakers. Since most
breaker dpyers use 2 fllses/breakers, make sure both are
operating.
Overloading/combining loads • Do not put more than one washer load in the dryer at
a time.
Underloading • If you are (hying only one or two items, add a few items to
ensure proper mlnbling.
Clothes are wrinkled Overdrying • Select a shorter (hying time.
• Remove items while they still hold a slight amount of
lnoisture.
Letting items sit in dryer after • Remove items when <Tcle ends and fold or hang
cycle ends imlnediately.
Clothes shrink Some fabrics will naturally shrink • To avoid shrinkage, fiollow gammnt care labels exactly.
when washed. Others can be • Some items may be pressed back into shape after dp)5ng.
safelywashed, but will shrink
in the dryer • If you are concerned about shrinkage in a particular item,
do not machine wash or mlnble (hy it.
13