General Electric Profile 473 Manual Del Propietário página 9

About reversing the door.
[] Need/e-nosed
priers
[--_ Open the door and remove tt_e filler plugs opposite the hinges. With d_e door
completely open, remove the bottom screw from each hinge on the (h)Terf:ace. Insert
these screws about halfway into the TOP holes, for each hinge, on the opposite side
(where you removed the filler plugs). Apply firm pressure to get the screw started in
untapped holes.
[_Loosen top screw from each hinge on d_e (hTer f:ace halfway. Witt_ one hand holding
the top of the door and the other hand holding the bottom, remove the door from the
(h)Ter 1)77 l ifting it UP and OUT.
[_Romte the door 180% Insert it on tt_e opposite side oldie opening by moving tt_e door
I/Vand DOWN until the top hinge and the bottom hinge are resting on the top screws
inserted in step 1.
; ¸2¸¸)¸¸¸¸¸ ¸
_ iii _i _ !!i ii_ _ i _!i _ i!i iii_ !i i li !i_ i!iii_ i!iii_ i_ _
[_Remove d_e remaining screws from the side of tt_e opening from which tt_e door was
removed. Witt_ tt_ese screws secure each hinge at d_e bottom. Tighten d_e t_,,'otop
screws of each hinge. Reinsert the plastic plugs on tt_e side from which the door was
removed.
9