VONROC AF504AC Traducción Del Manual Original página 5

Always check that the voltage of the power
supply corresponds to the voltage on the
rating plate.
If the supply cord is damaged, it must be
replaced by the manufacturer, its service
agent or similarly qualified persons in order
to avoid a hazard.
2. MACHINE INFORMATION
Intended use
The tower fan is intended for indoor, non-
commercial, household use for cooling residential
rooms. Do not use the product for any other
purpose. The tower fan can be used in enclosed of
open rooms in a free standing position. The tower
fan may only be used completely mounted and
standing vertically on a stable surface.
TECHNICAL SPECIFICATIONS
AF504 / AF504_WHITE
Model No.
AF505 / AF505_WHITE
Power supply 220~240V
Frequency 50-60Hz
Power rating 50W
Cable length 1.3 - 1.5m
Timer 15 hours
DESCRIPTION
The numbers in the text refer to the diagrams on
page 2.
Fig. A (Tower fan)
Fig. B (Control tower fan)
1. On/off button
2. Speed button
3. Wind button
4. Timer button
5. Oscillation button
6. Indication lights wind setting
7. Indication lights speed setting
8. Indication light oscillation
9. Indication light temperature
10. Indication light timer
11. Display
WWW.VONROC.COM
Fig. C (Remote control)
1. On/off button
2. Speed button
3. Wind button
4. Timer button
5. Oscillation button
3. ASSEMBLING
Tower fan (Fig. D)
• Take the two parts of the base out of the
packing box, and align the two holes in the base
and connect. Well assembled into a base. (1)
• Remove the base nut from the fan. (2)
• Place the power cord in the assembled base
slot, align the bottom of the fan with the
center hole of the base and three screw head
avoidance holes, install the base in the correct
direction on the body.
• Tighten the nut. (3)
Note: When installing the base, place the fan
upside down on the packaging foam or other soft
surface for avoid scratching.
Remote control (Fig. E)
The remote control use one button cells, model No.
CR2025 (3V). We recommend the use of Lithium
type battery for longer use.
Note: Please follow battery disposal instruction on
battery packaging, or contact your local councils
for safely disposal of batteries.
4. OPERATION
Check the device for damage before use
and only use in good working condition.
Starting the tower fan
• Plug in the calbe to the mains power outlet.
Product is in standby modus, power indicating
light is on.
Function of the control panel (Fig B)
• Push the "ON/OFF" button (1) to working state,
push it again to standby modus.
• Speed button (2): push to cycle between high,
medium or low fan speed. The speed indicator
(7) will show the setting.
EN
5