VONROC AF504AC Traducción Del Manual Original página 6

EN
• Oscillation button (5): Press the oscillation
button to activate the tower fan to swing. The
oscillate indicator (8) will light up. Press it again
to deactivate.
• Wind button (3): Press Press the mode button to
change between 3 modes 'Natural Wind', 'Night
mode' and 'Ordinary wind.
• Timer button (4): The timer can be set between
0 hour and 15 hours. The display will show the
duration currently set. The timer indicator (10)
will light up if it is active.
• After 60 seconds the display will automatically
turn off.
Function of the remote control (Fig C)
• Push the "ON/OFF" button (1) to working state,
push it again to standby modus.
• Speed button (2): push to cycle between high,
medium or low fan speed.
• Oscillation button (5): Press the oscillation
button to activate the heater to swing. The
oscillate indicator (8 in Fig. B) will light up.
Press it again to deactivate.
• Wind button (3): Press Press the mode button
to change between 3 modes 'Natural Wind',
Sleeping wind' and 'Ordinary wind.
• Timer button (4): The timer can be set between
0 hour and 15 hours. The display will show the
duration currently set. Put the plug into the
socket, products in standby, power indicating
light is on.
• After 60 seconds the display will automatically
turn off.
5. MAINTENANCE
Before cleaning and maintenance, always
switch off the machine and remove the
mains plug from the mains.
Always remove the plug from the socket
when the device is not being used.
Clean with neutral detergent and soft cloth.
TROUBLESHOOTING
In case the tower fan does not work well, we give you
subjoined some possible causes and their solutions.
6
Problem Possible cause Treatment
The tower fan does
The plug is loose,
not operate, even
bad connection.
when it is plugged
in and the switch
is turned on.
No power in
socket outlet.
The appliance
Abnormal noise. is not standing
upright.
ENVIRONMENT
Faulty and/or discarded electrical or
electronic apparatus have to be collected at
the appropriate recycling locations.
Only for EC countries
Do not dispose of power tools into domestic waste.
According to the European Guideline 2012/19/EU
for Waste Electrical and Electronic Equipment and its
implementation into national right, power tools that
are no longer usable must be collected separately
and disposed of in an environmentally friendly way.
WARRANTY
VONROC products are developed to the highest
quality standards and are guaranteed free of
defects in both materials and workmanship for the
period lawfully stipulated starting from the date of
original purchase. Should the product develop any
failure during this period due to defective material
and/or workmanship then contact VONROC directly.
The following circumstances are excluded from this
guarantee:
• Repairs and or alterations have been made
or attempted to the machine by unauthorized
service centers;
• Normal wear and tear;
• The tool has been abused, misused or
improperly maintained;
• Non-original spare parts have been used.
Pull out the
plug, check the
connection of the
plug and socket.
Then connect
again.
Insert the plug in
a proper socket.
Put the tower fan
on a level surface.
WWW.VONROC.COM