Huepar DT03CG Manual Del Usuario página 12

Step 3: Keep pressing and holding the
slope. When the lasers blink, the maximum slope range (3.5°) has
been reached.
C. Adjusting both axes:
Step 1: Press and hold the button
function LED（18） flashes rapidly. The X-axis slope adjustment is
now available.
Step 2: Keep pressing and holding the
slope in X axis. When the lasers blink, the maximum slope range
(3.5°) has been reached.
Step 3: Short press the button
function LED (18) flashes slowly. The Y-axis slope adjustment is now
available.
Step 4: Keep pressing and holding the
slope in Y axis. When the lasers blink, the maximum slope range
(3.5°) has been reached.
！
Note:
Short press button
3 sec.
to switch between X and Y axes.
3 sec.
or
1 sec.
for ≥3 seconds until the slope
or
to switch to Y axis. The slope
or
-11-
button to adjust
button to adjust
button to adjust
1 sec.