Publicidad
Idiomas disponibles
Idiomas disponibles
2. Vertical adjustment up to a max. of 3.5° :
Step 1: Short press
press
button to switch on the front vertical laser line.
Step 2: Press and hold button
function LED（18）flashes rapidly. Motor-driven adjustment of the
slope is now enabled.
Step 3: Keeping pressing and holding the
slope. When the lasers blink, the maximum slope range (3.5°) has
been reached.
3. Turn OFF the slope function
• Method 1: Press and hold the button
slope function LED (18) lights off. It will return to the self-leveling mode.
• Method 2: Short press
again. It will return to the self-leveling mode.
Note:
• To restore horizontal or vertical leveling, deactivate the slope
function.
！
• The automatic sensor is deactivated under slope function.
• Under Slope Function Mode, the laser beam(s) will blink about
every 3-5 seconds to notify the user it is not self-leveling now.
• For the slope function, laser lines are no longer aligned to the
horizontal or vertical plane. This is a specific feature of adjusted
laser lines.
to turn off the horizontal line. Then short
for ≥3 seconds until the slope
3 sec.
to turn OFF the laser unit and power ON
-12-
or
button to adjust
for ≥3 second until the
Publicidad
