Dometic WAECO MyFridge MF1F Instrucciones De Uso página 16

Operation
8 Operation
I
NOTE
If there is a fault with the device (e.g. due to electrostatic discharging), press
one of the function buttons so that the device works normally again.
8.1 Before initial use
➤ Clean the device for reasons of hygiene (chapter "Cleaning and care" on page 17).
8.2 Cooling drinks
A
NOTICE!
The device does not switch off automatically when cooling. Because the device
cools drinks up to 22 °C below the ambient temperature, the drinks can freeze.
When using glass containers, ensure that they are not cooled for too long as
otherwise the liquid will freeze and the glass will break.
➤ If you want to cool drinks, connect the device to a power source and press the "Cold"
button (fig. 3 1, page 4).
✓ The operating display lights up and the device begins cooling.
➤ If you wish to end cooling, press the "Off" button (fig. 3 2, page 4).
➤ To switch off the device, pull out the connecting cable.
8.3 Heating drinks
A
NOTICE!
You must open the drinks bottle before heating. The drink expands as it heats
and can burst the bottle if it is not open.
➤ If you want to heat drinks, connect the device to a power source and press the "Heat"
button (fig. 3 3, page 4).
✓ The operating display lights up and the device begins heating.
✓ The device stops heating automatically when the drink has been heated to a temper-
ature of around 60 °C . This prevents the device from overheating.
It warms the drink again if the temperature falls.
➤ To end heating, press the "Off" button.
➤ To switch off the device, pull out the connecting cable.
8.4 Connecting to the cigarette lighter
I
NOTE
If you connect the cooler to the cigarette lighter, remember that the ignition
must be turned on to supply it with power.
16
MyFridge MF1F
EN