Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Since excessive cutting may cause overload of
the motor or difficulty in controlling the tool, the
depth of cut should not be more than 1/8" (3
mm) at a pass when cutting grooves. When you
wish to cut grooves more than 1/8" (3 mm) deep,
make several passes with progressively deeper bit
settings.
11.6 USE THE STRAIGHT GUIDE
Optional accessory
1. Assemble the straight guide with the bolt and the
wing nut.
1
2
1
Bolt
2. Attach the straight guide to the router base with the
clamp screw.
1
1
Clamp screw
3. Loosen the wing nut on the straight guide and adjust
the distance between the bit and the straight guide.
At the desired distance, tighten the wing nut.
English (Original Instructions)
NOTICE
2
Wing nut
1
1
Wing nut
4. Move the tool with the straight guide flush with the
side of the workpiece.
If the distance (A) between the side of the workpiece
and the cutting position is too wide for the straight
guide, or if the side of the workpiece is not straight,
the straight guide cannot be used.
In this case, firmly clamp a straight board to the
workpiece and use it as a guide against the router
base. Feed the tool in the direction of the arrow.
A
11.7 USE THE STRAIGHT GUIDE FOR
CIRCULAR WORK
For circular work, assemble the straight guide as shown
in the figures. The minimum and maximum radius of
circles to be cut (distance between the center of circle
and the center of bit) are as follows:
•
Minimum: 2-3/4" (70 mm)
•
Maximum: 8-11/16" (221 mm)
For cutting circles between 2-3/4" (70 mm)and 4-3/4"
(121 mm) in radius.
12
Publicidad
