Publicidad
Idiomas disponibles
Idiomas disponibles
1
Center hole
For cutting circles between 4-3/4" (121 mm) and 221
mm 8-11/16" (221 mm) in radius.
1
1
Center hole
NOTE
Circles between 6-3/4" (172 mm) and 7-5/16" (186
mm) in radius cannot be cut using this guide.
1. Align the center hole in the straight guide with the
center of the circle to be cut.
2. Drive a nail less than 1/4" (6 mm) in diameter into
the center hole to secure the straight guide.
3. Pivot the tool around the nail in the clockwise
direction.
1
Nail
English (Original Instructions)
1
1
2
2
Center hole
12
MAINTENANCE
Always be sure that the tool is switched off and the
battery pack is removed before attempting to perform
inspection or maintenance.
Never use gasoline, benzine, thinner, alcohol or the
like. Discoloration, deformation or cracks may result.
13
OPTIONAL ACCESSORIES
These accessories or attachments are recommended
for use with your tool specified in this manual. The
use of any other accessories or attachments might
present a risk of injury to persons. Only use accessory
or attachment for its stated purpose.
•
Knob type grip (not included)
•
Plunge base (not included)
14
TECHNICAL DATA
Rated voltage
No load speed
Collet chuck capacity
Weight (without battery
pack)
Battery model
Charger model
15
LIMITED WARRANTY
LIMITED WARRANTY
GARANTIE LIMITÉE
Greenworks hereby warranties this product, to the
original purchaser with proof of purchase, for a period
of three (3) years against defects in materials, parts
or workmanship. Greenworks, at its own discretion, will
repair or replace any and all parts found to be defective,
through normal use, free of charge to the customer.
This warranty is valid only for units which have been
used for personal use, that have not been purchased
13
CAUTION
NOTICE
CAUTION
DC. 24 V
-1
10000-30000 min
1/4"
2.98 lbs (1.35 kg)
LB24A020/BAG708 and
other BAG series
2978602/2903102 and
other CAG series
3
YEAR
ANS
AÑOS
GARANTÍA
LIMITADA
EN
Publicidad
