GreenWorks PA371 Manual Del Operador página 8

1
1
1 Shaft lock
3 Tighten
5 Collet nut
2. Press the shaft lock and tighten the collet nut with
the wrench or tighten the collet nut securely with the
two wrenches.
1
1 Wrench
3 Tighten
1
1 Shaft lock
The shaft lock may not return to the original
position when you tighten the collet nut at the
installation of the router bit. The shaft lock returns
to the original position when you start the tool.
3. To remove the bit, follow the installation procedure
in reverse.
English (Original Instructions)
2
3
4
4
5
5
2 Loosen
4 Wrench
2
3
1
4
2 Loosen
4 Collet nut
NOTE
10.4 INSTALL OR REMOVE THE
ROUTER BASE
1. Open the lock lever of the router base, then insert
the tool into the router base aligning the groove on
the tool with the protrusion on the router base.
1 Lock lever
2. Close the lock lever.
3. Attach the dust nozzle to the router base, and then
tighten the thumb screw.
1
9
EN
1
2