MO-EL PETALO Uso Y Mantenimiento página 15

MODELS WITH REMOTE CONTROL
Both models are available with remote control to remotely control
the heater.
Insert 2 x 1.5V AAA batteries (not included in the package) into the
remote control, respecting the indicated polarities.
Connect the appliance to the power supply: the STAND-BY LED
lights up.
By pressing the ON button on the remote control, the product lights
up together with the ON LED.
Press the STAND-BY button on the remote control, or the button
on the product next to the LEDs, to turn off the lamp and return the
appliance to sleep mode.
Warning! The appliance is still live.
To detach the line completely press the switch (Fig. 1-A).
5. MAINTENANCE
Petalo heaters contain no moving parts and therefore very little
maintenance is required other than to ensure that there is no
excessive build-up of dust/dirt on the reflectors or emitters as this
can cause overheating and premature emitter failure. To clean the
appliance, wipe off with a damp cloth.
The accumulation of limestone or incrustations reduces the life and
the efficiency of the lamp; it is suggested therefore to avoid the
continued use in presence of water or salt fog. Eventual leavings
of salt water will have to be removed before the use, after having
disconnected the appliance, by means of soak in sweet water.
6. EMITTER AND SILICON BUMPERS REPLACEMENT
The emitters used in the Petalo are robust and if knocks and shock
vibrations are avoided, they will last for around 5000 hours. When
changing the lamp, also the silicon bumpers connected with the lamp
must be substituted. They should be substituted even before if there
are signs of aging. Due to the special sealing and anti-shock design
of the heater, the emitters are not intended to be user replaceable.
Please ensure that all emitters are replaced via the service network.
15