Publicidad
Idiomas disponibles
Idiomas disponibles
Comply with the standards described in the relative instruction
book for assembly and installation of the heater.
5. INSTALLING THE PRODUCTS
Use the instructions below to install the single heaters onto the pole.
For Aaren and HotTop models, secure the product support bracket
as shown in Fig.3.
For Iris models, secure the support bracket in the opposite direction.
Hathor models do not require a support bracket.
After installing the product, fasten the articulated support to the wall
using screws and anchors suited to the type of wall and as shown in
Fig.1 (triangle pointing downwards and cable exiting from the top).
We recommend positioning the product centrally on the bracket to
Secure the product bracket directly onto the final joint with screws and nuts.
Secure the product bracket directly onto the final joint with screws and nuts.
Position the supports for the product as per the specific instructions
Position the supports for the product as per the specific instructions
and place them approximately 25 cm apart.
and place them approximately 25 cm apart.
Bring the product near the articulated support and match the two
Bring the product near the articulated support and match the two
holes as shown in the figure, defining the chosen angle.
holes as shown in the figure, defining the chosen angle.
keep the weight balanced.
HATHOR
AAREN / HOTTOP
12
Publicidad
