MO-EL 4467 Uso Y Mantenimiento página 9

from the two ends to set the preferred inclination and tighten the
screws (Fig. 2).
• Join the product support bracket and the specific articulated joint
together (Fig.3).
• Pass the cable through the central hole of the product support bracket
and inside the support (Fig. 4).
During this last operation, make sure the cable does not get pinched
We recommend passing the cable through components one by one,
as they are added, and to pull it slightly before tightening the screws.
in between the various components.
Fig. 3
Fig. 4
Fig. 1
Fig. 2
9