Publicidad
Idiomas disponibles
Idiomas disponibles
Introduction
EN
Thank you for choosing the FitWood NUPPU rocking horse. Please read this manual carefully before
installation and follow each step closely to ensure the safe use of the product.
Keep this manual for future reference. If you need assistance with installation, please get in touch
with us directly.
FitWood Oy
Hautalankatu 20
33560 Tampere
Suomi
info@fitwood.com
Disclaimer
Read all instructions and follow assembly instructions carefully before using the product.
FitWood shall not be responsible for injury or damage caused by neglect of instructions contained in
this manual or FitWood's website, incorrectly following instructions, or misuse of the product.
The warranty covers only defects in the product, in which case the defective product or its parts
are primarily replaced with a new one. The warranty does not cover damage caused by misuse,
adverse conditions for product materials, or natural wear and tear. FitWood shall never be responsible
for consequential damages arising from the use of the product, defective or broken product, and
FitWood's liability is limited to repairing or replacing the faulty product.
Recommended tools
• Drill or screwdriver and Torx TX25 tip.
• Rubber hammer and wooden block.
Make sure you have the following parts
6
Assembly instruction
Always tighten the screws slowly. The material is wood and may crack as a result of excessive
force. After all the screws are in place, check that they are correctly tightened.
- Assemble the rocking horse on a soft surface, such as cardboard or a carpet.
- Remove all packaging material before assembly.
- Sort through all parts ahead of time to ensure you have everything you need.
Step 1
Place one of the sideboards on a soft surface with the holes for the dowels facing upwards. Attach
the wooden dowels to the straight boards up to the bottom of the holes intended for them.
Step 2
Attach the narrower straight board with the FitWood logo into the upper holes of the first sideboard
using the dowels. Use a rubber hammer and a wooden block if needed. Fasten the screw in place
while pressing the straight board against the sideboard. Fasten the lower straight board the same way.
EN
7
Publicidad
