Publicidad
Idiomas disponibles
Idiomas disponibles
UNPACKING
This product requires assembly.
Carefully remove the product and any accessories from
the box. Make sure that all items listed in the packing list
are included.
WARNING:
Do not use this product if any parts on the Packing List
are already assembled to your product when you unpack
it. Parts on this list are not assembled to the product by
the manufacturer and require customer installation. Use
of a product that may have been improperly assembled
could result in serious personal injury.
Inspect the product carefully to make sure no breakage
or damage occurred during shipping.
Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the product.
If any parts are damaged or missing, please call
1-800-525-2579 for assistance.
PACKING LIST
Edger
Handle Assembly
Blade Wrench
Operator's Manual
WARNING:
If any parts are damaged or missing do not operate this
product until the parts are replaced. Use of this product
with damaged or missing parts could result in serious
personal injury.
WARNING:
Do not attempt to modify this product or create
accessories not recommended for use with this product.
Any such alteration or modification is misuse and could
result in a hazardous condition leading to possible serious
personal injury.
ASSEMBLY
WARNING:
To prevent accidental starting that could cause serious
personal injury, always remove the battery pack from the
product when assembling parts.
TOOLS NEEDED
See Figure 2.
The following tool (not included or drawn to scale) is needed
for assembly:
Phillips screwdriver
CONNECTING THE UPPER AND LOWER
SHAFTS
See Figure 3.
Remove the battery pack if installed.
Locate the supplied Philips head screws and lock washers.
Locate and align the holes on the upper shaft with the
screw indentions on the lower shaft.
Insert the lower shaft into the upper shaft.
Insert each screw through a lock washer and into the
shaft holes as shown.
Using a Phillips head screwdriver, turn each of the two
screws until securely tightened.
ATTACHING THE FRONT HANDLE
See Figure 4.
Loosen and remove the wing nut and bolt from the handle.
Install the handle on the upper shaft in the area indicated
by the illustration.
Adjust handle up or down, if necessary, to desired operat-
ing position.
Reinstall the wing nut and bolt. Tighten wing nut to secure.
6 — English
Publicidad
