Orbegozo ADR 91 Manual De Usuario página 24

MANUAL USUARIO ADR 91
• UP ( + ) and DOWN ( - ) buttons
Used to adjust (increasing/decreasing) temperatures settings in 1O C/2O F(or 1O F) increments
in a range of 17ºC/62ºF to 30ºC/88ºF (or 86ºF).
NOTE: The control is capable of displaying temperature in degrees Fahrenheit or degrees
Celsius. To convert from one to the other, press and hold the Up and Down buttons at the same
time, for 3 seconds.
• ON-OFF Button
Power switch on/off.
• LED Display
Show the set temperature while on cool mode. While on DRY and FAN modes, it shows the
room temperature.
Error codes
E1- Room temperature sensor error - Unplug the unit and plug it back in. If error repeats, call for
service.
E2- Evaporator temperature sensor error - Unplug the unit and plug it back in. If error repeats,
call for service.
E4- Display panel communication error - Unplug the unit and plug it back in. If error repeats, call
for service.
Protection codes
P1- Bottom tray is full - Connect the drain hose and drain the collected water away. If error
repeats, call for service.
Cool operation
−
Press the "MODE" button until the "COOL" indicator light comes on. The unit will operate the
auto fan speed automatically.
−
Press the ADJUST buttons
temperature can be set within a range of 17ºC-30ºC/62ºF-88ºF(or 86ºF).
−
Press the "FAN" button on the remote controller to choose the fan speed.
Dry operation
−
Press the "MODE" button until the "DRY" indicator light comes on.
−
Under this mode, you cannot select a fan speed or adjust the temperature.
−
Keep windows and doors closed for the best dehumidifying effect.
−
Do not put the duct to window.
Fan operation
−
Press the "MODE" button until the "FAN" indicator light comes on. The unit will operate the
auto fan speed automatically. The temperature cannot be adjusted on fan mode.
−
Press the "FAN" button on the remote controller to choose the f an speed.
−
Do not put the duct to window.
or to select your desired room temperature. The
24