Publicidad
Idiomas disponibles
Idiomas disponibles
7.5 TROUBLESHOOTING
FR
FR
HAZARD ! RISK OF INJURY DUE TO ELECTRIC SHOCK.
ES
ES
BEFORE ANY TROUBLE SHOOTING, SWITCH OFF THE PRODUCT.
PT
PT
Problems
Probable cause
The chain is dull /
damaged
IT
IT
Nuts / screws are not
Excessive noise
well tight
EL
EL
The blade is not enough
There is a leak of gasoline
PL
PL
from to a defective
Gasoline leak
assemblying (drilled pipe/
bad connection)
RU
RU
The priming bulb has not
been pressed enough
KZ
KZ
The spark plug is dirty
UA
UA
The spark plug spring
doesn't match with the
plug
No engine start
RO
RO
The spark plug is
defective
EN
EN
The engine is flooded
Solutions
Qualification
Sharpen it or change it
CUSTOMER
by a new one
Screw the nut(s) /
CUSTOMER
screw(s)
Screw the nut(s) /
CUSTOMER
set
screw(s)
Find the leak location
AFTER SALES
and replace the part by
a new one
Press the priming
bulb until the gasoline
CUSTOMER
is visible inside (4-7
times)
Remove and clean the
electrode with a spark
CUSTOMER
plug brush (iron bristle
brush)
Remove and change
the spark plug by a
CUSTOMER
new one
Check is the spring
is still on the cap.
CUSTOMER
Otherwise change it by
a new one
Close the starter,
remove the spark plug,
clean the spark plug,
return the machine
CUSTOMER
and pull the rope 5 to
10 times to empty the
cylinder of gasoline
246
Problems
No engine start
SERVICE
No engine stop
overconsumption
The engine doesn't
go to the idle
speed
Probable cause
Solutions
The gasoline pipe is
Remove it and change
drilled
it by a new one
Resume the carburetor
The carburetor is not well
setting procedure from
adjusted
the beginning
The carburetor is
Test it and change it by
defective
a new one
The gasoline strainer is
Check its position or
not well placed (on the
replace it
bottom)
The starting cable is too
Change the cable
long
The switch is on OFF
Put the switch on ON
position
position
The OFF switch is
Test it and change it by
defective
a new one
The starting cable is too
Change the cable
short
The brake system is
Test it and change it by
defective
a new one
The trigger system is
Test it and change it by
defective
a new one
Resume the carburetor
Carburetor is not well
setting procedure from
adjusted /
the beginning
Gasoline filter is blocked
Replace it by a new one
Resume the carburetor
The carburetor idle speed
setting procedure from
screw is not well adjusted
the beginning
247
FR
FR
Qualification
AFTER SALES
SERVICE
ES
ES
AFTER SALES
SERVICE
PT
PT
AFTER SALES
SERVICE
IT
IT
CUSTOMER
AFTER SALES
EL
EL
SERVICE
CUSTOMER
PL
PL
AFTER SALES
SERVICE
RU
RU
AFTER SALES
SERVICE
KZ
KZ
AFTER SALES
SERVICE
AFTER SALES
UA
UA
SERVICE
AFTER SALES
SERVICE
RO
RO
AFTER SALES
SERVICE
EN
EN
AFTER SALES
SERVICE
Publicidad
