Publicidad
Idiomas disponibles
Idiomas disponibles
Attention! The fitting must be installed, flushed and
tested after the valid norms.
Assembly
1. Flush through the supply pipes.
2. Place the mixer including the sealing washer in
position on the basin.
3. Slip the fixation piece including the washer over
the threaded pins and tighten the nuts.
4. Connect the supply pipes to the isolation val-
ves;
cold right - hot left.
5. 31612000/31613000/31622000
Connect the pull rod to the pop-up waste.
The hot and cold supplies must be of equal pres-
sures.
Operation
The mixer is activated by lifting the lever handle.
Turning to the left = warmer water,
turning to the right = cooler water.
Technical Data
This mixer series-produced with water-dim-
mer
(flow limiter)
®
Rate of flow with waterdimmer: 7 l/min 0.3 MPa
Rate of flow without waterdimmer: 12 l/min 0.3 MPa
Operating pressure:
Recommended operating pressure: 0.1 - 0.5 MPa
Test pressure:
(1 MPa = 10bar = 147 PSI)
Hot water temperature:
Recommended hot water temp.:
Hansgrohe single lever mixers can be used toge-
ther with hydraulically and thermically controlled
continuous flow heaters if the flow pressure is at
least 0.15 MPa.
If the continuous water heater causes any problems or
there is not enough flow of water, the waterdimmer
(5a) located behind the aerator must be removed.
To adjust the hot water limiter on single lever mixers,
please see page 24.
No adjustment is necessary when using a continuous
flow water heater.
English
max. 1 MPa
1.6 MPa
max. 80° C
65° C
®
Spare parts (see page 2)
1
handle
1.1 screw cover
2
flange
flange gold plated
3
nut
4
cartridge cpl.
5
aerator cpl.
6
pop up rod
7
fixing set
8
connection hose 3/8"
9
connection hose Ø 10
Special accessoires
X
special tool set
(not part delivery)
31692000
96338000
97406000
96656990
97209000
92730000
13912000
96657000
96016000
97206000
96321000
58085000
Publicidad
