Publicidad
Idiomas disponibles
Idiomas disponibles
BM 2610033824 DDB181 02-14_DDB181 2/7/14 1:24 PM Page 8
Disconnect battery pack
W RNING
from tool before making
any assembly, adjustments or changing
accessories. Such preventive safety
measures reduce the risk of starting the tool
accidentally.
INSERTING BITS
Move reverse switch lever to the center "OFF"
position. Remove battery pack and rotate the
clutch
ring
to
"
". Rotate the chuck sleeve counter-
clockwise viewing from chuck end, and open
chuck to approximate drill bit diameter. Insert
a clean bit up to the drill bit flutes for small bits,
or as far as it will go for large bits. Close chuck
by rotating the chuck sleeve clockwise and
securely tighten by hand (Fig. 2).
BELT CLIP
When the tool is attached to
W RNING
the belt, position yourself to
avoid entanglement with surrounding objects.
Unexpected entanglement could cause the tool
to fall resulting in injury to the operator or
bystanders.
The belt clip accessory will allow you to
conveniently attach your tool to your belt. This
feature will allow you to have both hands free
when climbing a ladder or moving to another
work area.
The belt clip can be attached to either side of
the tool by securing it with a mounting screw.
Always make sure you securely tighten the
mounting screw before use (Fig. 3).
To use clip, turn tool upside down and attach
to your belt.
Assembly
the
drill
bit
symbol
Do not use the power of
W RNING
the drill while grasping
chuck to loosen or tighten bit. Friction burn
or hand injury is possible if attempting to grasp
the spinning chuck.
FIG. 2
CHUCK SLEEVE
DRILL BIT
SCREW-
DRIVER
BIT
-8-
BIT HOLDER
FIG. 3
BELT CLIP
Publicidad
