Publicidad
Idiomas disponibles
Idiomas disponibles
GB
F
D
E
I
MAINTENANCE
replaced immediately. Failure to do so could result
in a fire that could cause serious personal injury.
SPARK PLUG
This engine uses a Champion RCJ-6Y and Torch L7RTC
with 0.63 mm (0.025 in.) electrode gap. Use an exact
replacement and replace annually.
WARNING
Be careful not to cross-thread the spark plug.
Cross-threading will seriously damage the
product.
STORAGE (1 MONTH OR LONGER)
Drain all fuel from the tank into a container approved
■
for gasoline. Run engine until it stops.
IF THESE SOLUTIONS DO NOT SOLVE THE PROBLEM CONTACT YOUR AUTHORIZED SERVICING DEALER.
PROBLEM
Engine will not start.
Engine starts but will not
accelerate.
P
NL
S
DK
N
FIN GR HU
TROUBLESHOOTING
POSSIBLE CAUSE
1. No spark.
2. No fuel.
3. Engine is flooded
4. Starter rope pulls harder now
than when new.
Carburetor requires adjustment.
CZ RU
RO PL SLO HR TR EST LT
English
English
Clean all foreign material from the blower. Store it in
■
a well-ventilated place that is inaccessible to children.
Keep away from corrosive agents such as garden
chemicals and de-icing salts.
Abide by all Federal and local regulations for the safe
■
storage and handling of petrol. Excess fuel should be
used up in other 2-stroke engine powered equipment.
1. Check spark. Remove spark plug. Reattach
the spark plug cap and lay spark plug on
metal cylinder. Pull the starter rope and watch
for spark at spark plug tip. If there is no spark,
repeat test with a new spark plug.
2. Push primer bulb until fuel is visible in the
bulb. If fuel is not apparent, the primary
fuel delivery system is blocked. Contact a
servicing dealer. If primer bulb fills, engine
may be flooded (see next item).
3. Remove spark plug, turn blower so spark plug
hole is aimed at the ground. Rotate the choke
dial to "RUN" position and pull starter cord 10
to 15 times. This will clear excess fuel from
en gine. Clean and reinstall spark plug. Pull
starter three times with choke dial at "RUN".
If en gine does not start, rotate choke dial to
"FULL CHOKE" position and repeat normal
starting pro ce dure. If engine still fails to start,
repeat pro ce dure with a new spark plug.
4. Contact a servicing dealer.
Contact a servicing dealer for carburetor
adjustment.
11
11
LV
SOLUTION
SK BG
Publicidad
